TEST ELECTRONICS’ TE-9000 Test Fixture
High Performance Pneumatic Actuated PC Board Test Fixture

TE-9000 PC Board Test Fixture
Test Electronics will customize the TE-9000 bed of nails style test fixture for your circuit board and test application. Next, add a Genrad 2270/71/72/75/76/8X or a Hewlett/Packard 3060/61/62/65/70/72/75 or a Teradyne 800/10/75 & 1800/10/20 or a Checksum, TTI, Testronics, or any other MDA This will create a complete full performance cost efficient functional, in-circuit, or bare board tester.

Quick Test Plate Changeover
Test plate changeover is a quick 2 minuit job. Thumbscrews to change the bottom plate and 4 SHC screws to change the top plate. The old plates lift out and the new plates drop in. Connectors are mounted underneath the bottom plate and lift out along with the plates. We pride ourselves in our efficient designs.
We emphasize our Understand-it-at-a-glance motto
for intuitive easy to learn operation.

View of the Pneumatic Components
Shown above is a view of the pneumatic components. This unit provides dual level testing. The main cylinders provide the first 18" of travel and compresses the highest set of test pins. The lower short cylinders provide a maximum of 1/2" of travel. This travel is typically adjusted to 0.1" and used to compress the second group of test pins for a more extensive test.

Wiring and Customization
Signal and data pins are wire wrapped from the test pin to an internally mounted connector. This connector is then cabled to an instrument board. This instrument board is typically located in a computer mounted in the lower part of the fixture, or in a rack cabinet near the fixture. Higher speed signals, and noise sensitive signals are wired with twisted pairs or coaxial cable. All wiring is neatly bundled for easy troubleshooting and modification. Cable lengths are kept as short as possible to maintain high performance.

Test Plate Customization
Extreme care is taken in the manufacture of all plates. All plates are precision ground, buffed to a high gloss, center drilled, then finally, drilled to an accuracy of 1/10 of a thousandth with carbide drill bits running at 20,000 RPM under high pressure coolant. Receptacles are then inserted and swaged with a custom built CNC machine providing an extremely high degree of perpendicularity exceeding 1/1000" per linear foot.

Compatibilities:
» Checksum, TTI, Testronics, and Other MDA's
» Genrad 2270/71/72/75/76/8X
» Hewlett/Packard 3060/61/62/65/70/72/75
» Tektronix MI 5010 Multifunction Interface System
» Teradyne 800/10/75 & 1800/10/20

Computer Test system compatiblity:
» Windows Operating System
» Mac Operating System

Test Electronics, a leader in test fixture technology. Creating innovations in testing by utilizing the latest high tech tools to their full potential.

View Adobe PDF File
Back to Bed of Nails Fixtures
E-mail Applications Engineering
Go to Home Page
End of page