TEST ELECTRONICS’ TE-5000 Test Fixture
High Performance Lever Actuated PC Board Test Fixture
Single and Double Sided Access

TE-5000 PC Board Test Fixture
Test Electronics will customize the TE-5000 bed of nails style test fixture for your circuit board and test application. Next, add a desktop or rack mount computer, plug in the data aquisition boards and software. This will create a complete full performance cost efficient functional, in-circuit, or bare board tester.
Quick and Simple 2 step operation
1. Insert the circuit board under test in the tester.
2. Pull the lever.
The bottom plate holds the board under test and raises it. This presses the board into the spring loaded test pins making contact with the circuit board under test.

Mechanical
The tester is comprised of 2 plates. The top stationary bed of nails plate and a bottom push plate.
1. The spring loaded test probes are mounted in the top plate and are typically wired out to connectors on the back panel.
2. The bottom push plate holds the tooling pins and the board under test. This plate pushes the board up into the top bed of nails plate.
4. Patented High accuracy roller bearings combined with state of the art anti sway technology holds tight tolerances over long term industrial use keeping the plates parallel within .001" / linear ft.
5. The chassis is built with industrial strength .090" aluminum, reinforced with a heavy duty 3/8" aluminum inner frame.

Inside View
This view with the top cover open. This shows the easy accessibility provided by our fixture designs. The pins shown in this plate will be wire wrapped to the rear panel connectors and an internal power supply and any variety of internal signal conditioning boards. Low speed signals and data pins are wire wrapped directly to the appropriate rear panel connectors where they are cabled out to an insrument board. Higher speed signals, and noise sensitive signals are wired with twisted pairs or coaxial cable. All wiring is neatly bundled for easy troubleshooting and modification. Extreme care is taken in the manufacture of all plates. All plates are precision ground, buffed to a high gloss, center drilled, then finally, drilled to an accuracy of 1/10 of a thousandth with carbide drill bits running at 20,000 RPM under high pressure coolant. Receptacles are then inserted and swaged with a custom built CNC machine providing an extremely high degree of perpendicularity exceeding 1/1000" per linear foot.

Quick Test Plate Changeover
Test plate changeover is a quick 2 minuit job. 4 thumbscrews to change the bottom plate and 4 SHC screws to change the top plate. The top plate drops down and slides out with the connector assembly. The bottom plate lifts up and out. The new plates slide back in. All rear panel connectors are mounted to the aluminum bracket on the top plate. This whole top plate assembly slides out together eliminating wiring hassels. Double sided access plate sets use transfer pins to get the signals from the bottom plate up to the top plate. We pride ourselves in our efficient designs. We emphasize our Understand-it-at-a-glance motto for intuitive easy to learn operation.

Compatibilities:
» Checksum, TTI, Testronics, and Other MDA's
» Genrad 2270/71/72/75/76/8X
» Hewlett/Packard 3060/61/62/65/70/72/75
» Tektronix MI 5010 Multifunction Interface System
» Teradyne 800/10/75 & 1800/10/20

Computer Test system compatiblity:
» Windows Operating System
» Mac Operating System

Test Electronics, a leader in test fixture technology has teamed up with National Instruments a leader in Virtual instrumentation to bring you high quality cost effective solutions to functional, in-circuit, and bare board testing!
The PCI-6071E DAQ Boards shown here are products of National Instruments tm

Test Electronics, a leader in test fixture technology. Creating innovations in testing by utilizing the latest high tech tools to their full potential.

View Adobe PDF File
Back to Bed of Nails Fixtures
E-mail Applications Engineering
Go to Home Page
End of page